PENYIMPANGAN DIMENSI PROSES PRODUKSI GEAR DENGAN MENGGUNAKAN TEKNOLOGI DLP (DIGITAL LIGHT PROCESSING) 3D PRINTER
Main Article Content
Abstract
Downloads
Article Details
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
The Authors submitting a manuscript do so on the understanding that if accepted for publication, Authors retain copyright and grant the AUSTENIT right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
AUSTENIT, the Editors and the Advisory International Editorial Board make every effort to ensure that no wrong or misleading data, opinions or statements be published in the journal. In any way, the contents of the articles and advertisements published in AUSTENIT are the sole responsibility of their respective authors and advertisers.
References
D. Seprianto, R. Wilza, dan Iskandar. 2017. Optimasi Parameter Pada Proses Pembuatan Objek 3D Printing Dengan Teknologi FDM Terhadap Akurasi Geometri. Seminar Nasional Teknik Industri Universitas Gadjah Mada 2017. ISBN 978-602-73461-6-1.
I. Taufik, Herianto, dan M.K. Herliansyah. 2017. Monitoring dan Analisis Mesin 3D Printing Berbasis Sensor Getaran Untuk Mengoptimalkan Kualitas Hasil. Proceeding International Seminar 1st ECOSTECH.
M.E. Fabio dan A.E. Tontowi. 2018. Optimasi Parameter Proses Pada 3D Printer Jenis Digital Light Processing (DLP) Menggunakan Metode Response Surface Untuk Mencetak Prototype Stent Dengan Tipe Kecacatan Terendah. www.http://etd.repository.ugm.ac.id/penelitian/detail/165897#filepdf (diakses 26 Juli 2020).
M. Ginting, D. Seprianto, dan R. Wilza. 2017. Desain dan Rancang Bangun Alat Bantu Press Tool untuk Meningkatkan Produktivitas UKM Metal Furniture. Jurnal Austenit Teknik Mesin Politeknik Negeri Sriwijaya Vol. 9 No.1 ISSN 2085-1286.
Setiawan, Agris. 2017. Pengaruh Parameter Proses Ektrusi 3D Printer Terhadap Sifat Mekanis Cetak Komponen Berbahan Filament PLA (Poly Lactide Acid). Jurnal Teknika STTKD Vol.4, No.2, ISSN : 2460-1608.
Sudjana, 1986. Metoda Statistika, Edisi ke IV, Penerbit Tarsito Bandung.