ANALISA PARAMETER KEKASARAN PERMUKAAN BAHAN ALUMUNIUM JENIS Al Mg Si 3.6082 DIN 1725 PADA PROSES PEMESINAN CNC MILLING

Authors

Keywords:

CNC Milling, Al Mg Si 3.6082 DIN 1725, surface roughness, linier regression

Abstract

Machining process will produce a good product / work in accordance with the instructions specified by the finishing process, while still a lot of operator / mechanic machine tools are still faced with determining machining parameters such as cutting speed, feed rate, and the dept of cut.Melalui results of this study expected to contribute a measure of optimal parameters in CNC operations carried out by means of experiments Milling.Penelitian Al Mg Si material 3.6082 DIN 1725 using a CNC Milling. Any specimen that has been done on a CNC Milling with three variations of cutting speed, feed rate, and the dept of cut measured surface roughness (Ra). From the results of further experimental data are analyzed with regression models to obtain mathematical models. Mathematical models that produced a regression equation Y = 0.880-0.001 n- 0.004 f + 0.316 a 69.8% level of eligibility.

Downloads

Download data is not yet available.

Downloads

Published

2012-04-01

Issue

Vol. 4 No. 01 (2012): AUSTENIT: April 2012

Section

Articles

License

The Authors submitting a manuscript do so on the understanding that if accepted for publication, Authors retain copyright and grant the AUSTENIT right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.

AUSTENIT, the Editors and the Advisory International Editorial Board make every effort to ensure that no wrong or misleading data, opinions or statements be published in the journal. In any way, the contents of the articles and advertisements published in AUSTENIT are the sole responsibility of their respective authors and advertisers.

How to Cite

yunus, moch, Suryana, D., & Mulyadi, M. (2012). ANALISA PARAMETER KEKASARAN PERMUKAAN BAHAN ALUMUNIUM JENIS Al Mg Si 3.6082 DIN 1725 PADA PROSES PEMESINAN CNC MILLING. AUSTENIT, 4(01). https://jurnal.polsri.ac.id/index.php/austenit/article/view/133

Similar Articles

111-120 of 221

You may also start an advanced similarity search for this article.

Most read articles by the same author(s)

1 2 3 > >>