MIX DESIGN “BASE A†PADA PENINGKATAN JALAN TELANG JAYA-SUMBER MARGA TELANG, KABUPATEN BANYUASIN
DOI:
https://doi.org/10.36257/apts.v5i2.4378Keywords:
Key word : mix-design, CBR, Base AAbstract
Abstract
Aggregat foundation A is a pavement layer located between the surface course and the sub-base course, It is a pavement layer that functions to withstand vehicle loads and as a surface layer palcment, therefore the material to be used must be strong and resistant, and must meet the General sfesifications for road construction.
Aggregate gradation, aggregate cleanliness, wear, shape dan surface of the aggregate greatly affect the density and bearing capacity of Base A, therefore PT. Sriwijaya Indo Utama, which will carry ot the project on Telang Jaya-Sumber Telang Road, Muara Telang Jaya District- Sumber Marga Telang, Banyuasin Regency, has asked for a “Base A†mix design in the Materials Testing Laboratory of the Sriwijaya State Polytechnic.
The results of testing the physical properties and baering capacity (CBR) of “Base Aâ€, meet the General specifications for road construkstion, so that the mix-design of aggregate Base A can be applied in the project.
Key word : mix-design, CBR, Base A
Downloads
References
REFERENSI
Dinas Pekerjaan Umum dan Perumahan Rakyat, “Spesifikasi Umum 2018 Divisi 5 Perkerasan Berbutir Dan Perkerasan Beton Semen,†pp. 1–72, 2018.
Badan Standardisasi Nasional, SNI 03-1968-1990, "Metode Pengujian Tentang Analisis Saringan Agregat Halus dan Kasar,â€, pp. 1–5, 1990.
Badan Standardisasi Nasional, SNI 2417-2008, “Cara uji keausan agregat dengan mesin abrasi Los Angeles,†p. 20, 2008.
Badan Standardisasi Nasional, “Cara uji penentuan batas cair tanah,†SNI 1967-2008, p. 25, 2008.
Badan Standardisasi Nasional, “Metode pengujian batas plastis tanah,†SNI 1966-2008, pp. 2–3, 2008.
Badan Standardisasi Nasional, “Metode pengujian gumpalan lempung dan butir-butir mudah pecah dalam agregatâ€, SNI 03-4141-1996, Pusjatan-Balitbang PU, pp. 1–6, 1996.
Badan Standarsisasi Nasional, “Metode Uji Penentuan Persentase Butir Pecah pada Agregat Kasar,†SNI- 7619-2012, pp. 2–20, 2012.
Badan Standardisasi Nasional, “Cara uji kepadatan berat untuk tanahâ€, SNI-1743-2008, p. 20, 2008.
SNI 1744, “Metode uji CBR laboratoriumâ€, SNI 1744-2012, pp. 1–28, 2012.
R. L. KS and S. Suhendra, “Pengaruh Variasi Gradasi Pada Agregat Terhadap Nilai Kuat Tekan Cement Treated Base (Ctb)â€, Jurnal Talenta Sipil, vol. 1, no. 2, p. 80, 2018, doi: 10.33087/talentasipil.v1i2.11.
R. Chaulagai et al., “Influence of maximum particle size, fines content, and dust ratio on the behavior of base and subbase coarse aggregatesâ€, Transportation Research Record, vol. 2655, no. November 2018, pp. 20–26, 2017, doi: 10.3141/2655-04.
M. T. Miah and E. Oh, “Investigation Of Cbr-Values Of Granular Sub Base In Various Degree Of Saturation (Dos)â€, International Journal of GEOMATE, vol. 20, no. 77, pp. 98–106, 2021, doi: 10.21660/2020.77.24546.
Downloads
Published
Issue
Section
License
Copyright (c) 2022 Aptekmas : Jurnal Pengabdian Kepada Masyarakat
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
